 |
|
|
Plate Evaporator:
The equipment is hoist mode evaporator; the materials pass among the plates and evaporated after being heated by the steam. The gas and fluid mixture is discharged
form the exit and enters the separator, separating the gas and fluid in it so as
to obtain condensed materials and secondary steam. In multi-level evaporation, the
condensed materials and secondary steam will enter the next level evaporator
to evaporate.
The core element of the equipment is heat transfer plate; each plate's effective
heat exchange area is 0.4m?, 4 plates of different configuration form a group.
According to engineering requirements, a set of plate evaporators may consist
of several or dozens of groups, and mounted in the framework which is comprised
of the fixed pressure plate, active pressure plate, front strut, top and bottom
guide bar, and pressure stud.
The equipment structure is compact and efficient (the total drive coefficient is
2 - 4 times the pipe evaporator). It is also very convenient to remove, install
and clean. Fluid holding volume is very low; the materials' exposure to high temperature is short. The equipment can be used for juice, dairy, and other material
condensation.
Manufacture material:
1) Plate, connecting pipe: 304, 316, 316L
2) Gasket: standard BUNa-N and EPDM which are complied with food rubber gasket
3) Framework: carbon steel, the direct contacts with the materials would all be furred
with stainless steel, or covering the entire surface of carbon steel with stainless
steel according to the customers' requirements
If this offer has interested you, please, fill the form of inquiry and you receive the answer in ASAP. |
|
|
|
